2013-2015 Land Cruiser Prado · Service Manual Drivetrain

REPLACEMENT

Removal / installation · Vehicles built from Aug 2013

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. REMOVE FRONT WHEEL

2. REMOVE DISC BRAKE CYLINDER ASSEMBLY LH

  1. F043120
    Using a union nut wrench, disconnect the brake tube from the disc brake cylinder assembly.

    HINT:
    Use a container to catch brake fluid as it drains out.

  1. F043121
    Remove the 2 bolts and disc brake cylinder assembly.


3. REMOVE FRONT DISC

  1. C215913E01
    Place matchmarks on the disc and axle hub if planning to reuse the disc.
    Text in Illustration 
    *1
    Matchmark

  1. Remove the front disc.


4. REMOVE FRONT AXLE HUB BOLT LH

F044194E03
  1. Using SST and a screwdriver or equivalent to hold the axle hub, remove the front axle hub bolt.

    SST
    09611-12010  
    Text in Illustration 
    *1
    Nut
    *a
    Turn
    *b
    Hold

    NOTICE:
    Do not damage the threads of the hub bolt.


5. INSTALL FRONT AXLE HUB BOLT LH

C098706E03
  1. Insert a new hub bolt.

  1. Temporarily install a washer and hub nut to the hub bolt as shown in the illustration.

    Text in Illustration 
    *1
    Washer
    *2
    Nut
    *a
    Turn
    *b
    Hold

    NOTICE:
    Install a hub nut to prevent damage to the hub bolt.

  1. Using a screwdriver or equivalent to hold the hub, turn the hub nut until the bottom surface of the hub bolt head touches the axle hub.

  1. Remove the hub nut and washer.

    NOTICE:
    Do not damage the threads of the hub bolt.


6. INSTALL FRONT DISC
  1. Align the matchmarks and install the front disc.

    HINT:
    When replacing the disc with a new one, select the installation position where the disc has the smallest runout.


7. INSTALL DISC BRAKE CYLINDER ASSEMBLY LH
  1. Install the disc brake cylinder assembly with the 2 bolts.

    Torque:
    123 N*m{ 1254 kgf*cm , 91 ft.*lbf }

  1. Using a union nut wrench, connect the brake tube to the disc brake cylinder assembly.

    Torque:
    15 N*m{ 155 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click here).


8. INSTALL FRONT WHEEL

Torque:
112 N*m{ 1142 kgf*cm , 83 ft.*lbf }

← COMPONENTS (from Aug 2013)COMPONENTS (from Aug 2013) →