2013-2015 Land Cruiser Prado · Service Manual Drivetrain

INSTALLATION

Removal / installation · Vehicles built from Aug 2013


1. INSTALL CLUTCH MASTER CYLINDER PUSH ROD CLEVIS BUSH

C215436E01
  1. Apply MP grease to the inside of a new clevis bush.

    Text in Illustration 
    *1
    MP grease

  1. Install the clevis bush to the clutch pedal.

    HINT:
    Install the clevis bush from the left side of the vehicle.


2. INSTALL CLUTCH PEDAL TURNOVER BUSH

C215434E01
  1. Apply MP grease to the turnover bush.

    Text in Illustration 
    *1
    MP grease

  1. Install the turnover bush to the clutch pedal.


3. INSTALL NO. 1 CLUTCH PEDAL CUSHION
  1. Install the 3 cushions to the clutch pedal.


4. INSTALL CLUTCH PEDAL SHAFT COLLAR

C215428E01
  1. Apply MP grease to the shaft collar.

    Text in Illustration 
    *1
    MP grease

  1. Install the shaft collar to the clutch pedal.


5. INSTALL CLUTCH PEDAL BUSH

C215427E01
  1. Apply MP grease to 2 new bushes.

    Text in Illustration 
    *1
    MP grease

  1. Install the 2 bushes to the clutch pedal.


6. INSTALL CLUTCH PEDAL PAD

7. INSTALL CLUTCH PEDAL STOPPER BOLT (w/o Cruise Control)
  1. Install the stopper bolt and temporarily install the lock nut.

    HINT:
    Tighten the lock nut to the specified torque when adjusting the clutch pedal.


8. INSTALL CLUTCH SWITCH ASSEMBLY (w/ Cruise Control)
  1. Install the clutch switch and temporarily install the lock nut.

    HINT:
    Tighten the lock nut to the specified torque when adjusting the clutch pedal.


9. INSTALL CLUTCH PEDAL SPRING HOLDER

C215424E01
  1. Apply MP grease to the contact surface of the spring holder.

    Text in Illustration 
    *1
    MP grease

  1. Install the spring holder.


10. INSTALL CLUTCH PEDAL SUB-ASSEMBLY
  1. Install the clutch pedal and washer to the clutch pedal support with the nut and bolt.

    Torque:
    34 N*m{ 350 kgf*cm , 25 ft.*lbf }

    HINT:
    Install the bolt from the left side of the vehicle.


11. INSTALL TURN OVER SPRING SEAT COMPRESSION SPRING
  1. Install the compression spring to the clutch pedal and spring holder.


12. INSTALL CLUTCH MASTER CYLINDER ASSEMBLY
  1. Install the clutch master cylinder (Click here).

← ADJUSTMENT (from Aug 2013)COMPONENTS (from Aug 2013) →