2013-2015 Land Cruiser Prado · Service Manual Drivetrain

REMOVAL

Removal / installation · Vehicles built from Aug 2013


1. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
  1. Remove the lower No. 1 instrument panel airbag (Click here).


2. REMOVE CLUTCH MASTER CYLINDER ASSEMBLY
  1. Remove the clutch master cylinder (Click here).


3. REMOVE CLUTCH PEDAL ASSEMBLY

C215441
  1. Remove the bolt and clutch pedal.


4. REMOVE CLUTCH START SWITCH ASSEMBLY

  1. C215541
    for LHD:

    1. Disconnect the clutch start switch connector.

    2. Remove the nut and clutch start switch.

  1. C215542
    for RHD:

    1. Disconnect the clutch start switch connector and detach the clamp.

    2. Remove the nut and clutch start switch.


5. REMOVE TURN OVER SPRING SEAT COMPRESSION SPRING

C215443
  1. Remove the compression spring.


6. REMOVE CLUTCH PEDAL SUB-ASSEMBLY

C215444
  1. Remove the nut, washer and bolt.

  1. Remove the clutch pedal from the clutch pedal support.


7. REMOVE CLUTCH PEDAL SPRING HOLDER

C215445
  1. Remove the spring holder from the clutch pedal support.


8. REMOVE CLUTCH SWITCH ASSEMBLY (w/ Cruise Control System)

C215447
  1. Loosen the lock nut and remove the clutch switch.


9. REMOVE CLUTCH PEDAL STOPPER BOLT (w/o Cruise Control System)

C215446
  1. Loosen the lock nut and remove the stopper bolt.


10. REMOVE CLUTCH PEDAL PAD

11. REMOVE CLUTCH PEDAL BUSH

C217707
  1. Remove the 2 bushes from the clutch pedal.


12. REMOVE CLUTCH PEDAL SHAFT COLLAR

C217708
  1. Remove the shaft collar.


13. REMOVE NO. 1 CLUTCH PEDAL CUSHION

C215450
  1. Using needle-nose pliers, remove the 3 cushions from the clutch pedal.


14. REMOVE CLUTCH PEDAL TURNOVER BUSH

C215449
  1. Remove the turnover bush from the clutch pedal.


15. REMOVE CLUTCH MASTER CYLINDER PUSH ROD CLEVIS BUSH

C215452
  1. Using an 8 mm hexagon wrench and hammer, remove the clevis bush.

← COMPONENTS (from Aug 2013)ADJUSTMENT (from Aug 2013) →