2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

DISASSEMBLY

Removal / installation · Vehicles built from Aug 2013


1. REMOVE STARTER YOKE ASSEMBLY

  1. A074096E02
    Remove the nut, and then disconnect the lead wire from terminal C.

  1. Remove the 2 through bolts.

  1. Pull out the starter yoke together with the starter armature.

  1. Remove the O-ring from the starter yoke.


2. REMOVE MAGNET STARTER SWITCH ASSEMBLY

A161053
  1. Remove the 2 screws and magnet starter switch.

  1. A161054E03
    Remove the idle gear, retainer, clutch roller, return spring and starter clutch from the starter drive housing.
    Text in Illustration 
    *1
    Starter Drive Housing
    *2
    Starter Clutch
    *3
    Return Spring
    *4
    Clutch Roller
    *5
    Retainer
    *6
    Idle Gear

  1. A115020E03
    Using a magnet hand, remove the steel ball from the clutch.
    Text in Illustration 
    *1
    Magnet Hand


3. REMOVE STARTER BRUSH HOLDER ASSEMBLY

  1. A062428E01
    Remove the 2 screws and commutator end frame from the starter yoke.

  1. Remove the O-ring from the starter yoke.

  1. Disconnect the 4 brushes from the starter brush holder.

    1. A062429E01
      Using a screwdriver, hold back the brush spring.

    2. Disconnect the brush from the brush holder.

  1. Remove the brush holder from the starter yoke.


4. REMOVE STARTER ARMATURE ASSEMBLY
  1. Remove the starter armature from the starter yoke.

← REMOVAL (from Aug 2014)INSPECTION (from Aug 2013) →