2013-2015 Land Cruiser Prado · Service Manual Power Source / Network

REMOVAL

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
  2. When disconnecting the cable, some systems need too be initialized after the cable is reconnected (Click here).


2. REMOVE AIR CLEANER AND HOSE

  1. A223920
    Detach the 3 clamps and disconnect the mass air flow meter connector.

  1. A223921
    Detach the 4 clamps.

  1. Loosen the hose clamp and remove the air cleaner and hose.


3. REMOVE FAN AND GENERATOR V BELT

  1. A099194E01
    Use the hexagonal part indicated by the arrow in the illustration to move the tensioner pulley downward and decrease the tension in the V belt. Then remove the V belt.

    NOTICE:
    When removing the V belt, do not use the bolt of the idle pulley.

    HINT:
    After removing the drive belt, move the tensioner upward to the maximum amount.


4. REMOVE GENERATOR ASSEMBLY

  1. A223928
    Remove the terminal cap.

  1. Remove the nut and generator wire.

  1. Disconnect the generator connector.

  1. A223930
    Remove the 2 bolts and generator.

← COMPONENTS (from Aug 2014)REMOVAL (from Aug 2014) →