2013-2015 Land Cruiser Prado · Service Manual Suspension

TC and CG Terminal Circuit

Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

DTC output mode is set by connecting terminals 13 (TC) and 4 (CG) of the DLC3. The DTCs are output by the blinking of the tire pressure warning light.

WIRING DIAGRAM

C171960E06

HINT:
When each warning light blinks continuously, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in each ECU is suspected.


INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (DLC3 - ECU AND BODY GROUND)
  1. Disconnect the tire pressure warning ECU and receiver R41 connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G48-13 (TC) - R41-3 (TC)
    Always
    Below 1 Ω
    G48-13 (TC) or R41-3 (TC) - Body ground
    Always
    10 kΩ or higher
    G48-4 (CG) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR OR EACH ECU
OK

CHECK PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← ECU Power Source Circuit (from Aug 2014)TC and CG Terminal Circuit (from Aug 2014) →