2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

REMOVAL

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use the same procedure for the LH and RH sides.
  2. The procedure listed below is for the LH side.


1. REMOVE ROOF HEADLINING ASSEMBLY
  1. Remove the roof headlining assembly (Click here).


2. REMOVE NO. 1 ROOF SIDE RAIL GARNISH LH

B242805E01
  1. Detach the 5 clips.

  1. Cut off clip A.

  1. Remove the roof side rail garnish.

  1. Remove clip A from the vehicle body.

    Text in Illustration 
    *1
    Clip A


3. REMOVE QUARTER WINDOW ASSEMBLY LH

B239030E01

HINT:
Apply protective tape to the outer surface of the vehicle body to prevent scratches.

NOTICE:
When separating the quarter window glass from the vehicle, be careful not to damage the vehicle paint or interior/exterior ornaments.

  1. From the interior, insert a piano wire between the vehicle body and quarter window glass as shown in the illustration.

    Text in Illustration 
    *1
    Protective Tape
    *2
    Piano Wire

  1. B242804E01
    Tie objects that can serve as handles (for example, wooden blocks) to both wire ends.

  1. Cut through the adhesive by pulling the piano wire around the quarter window glass.

    NOTICE:
    Leave as much adhesive on the vehicle body as possible when removing the quarter window glass.

    Text in Illustration 
    *1
    Piano Wire
    *2
    Wooden Blocks
    *3
    Protective Tape

  1. Using suction cups, remove the quarter window glass.


4. CLEAN VEHICLE BODY

B106081E18
  1. Clean and shape the contact surface of the vehicle body.

    Text in Illustration 
    *1
    Adhesive
    *2
    Vehicle Body

    1. On the contact surface of the vehicle body, use a knife to cut away excess adhesive as shown in the illustration.

      HINT:
      Leave as much adhesive on the vehicle body as possible.

      NOTICE:
      Be careful not to damage the vehicle body.

    2. Clean the contact surface of the vehicle body with cleaner.

      HINT:
      Even if all the adhesive has been removed, clean the vehicle body.

← COMPONENTS (from Aug 2013)REMOVAL (from Aug 2014) →