2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

AVC-LAN Circuit

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

Each navigation system component connected to the AVC-LAN (communication bus) transfers switch signals using the audio visual communication local area network.
If a short to +B or short to ground occurs in the AVC-LAN, the audio system will not function normally because communication is not possible.

WIRING DIAGRAM

E286348E01

INSPECTION PROCEDURE

HINT:
The navigation receiver assembly is the master unit.


1. INSPECT NAVIGATION RECEIVER ASSEMBLY

  1. E280968E04
    Remove the navigation receiver assembly (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    7 (TX1+) - 8 (TX1-)
    Always
    60 to 80 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Navigation Receiver Assembly)



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (AVC-LAN CIRCUIT)
  1. Disconnect the h61 navigation receiver assembly connector.

  1. Disconnect the H63 stereo component amplifier assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H56-7 (TX1+) - H63-8 (TX+)
    Always
    Below 1 Ω
    H56-8 (TX1-) - H63-7 (TX-)
    Always
    Below 1 Ω
    H56-7 (TX1+) - Body ground
    Always
    10 kΩ or higher
    H56-8 (TX1-) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT MALFUNCTIONING PARTS
  1. Disconnect and reconnect each slave unit one by one until the master unit returns to normal operation.

    HINT:
    1. Check all slave units.
    2. When disconnecting a slave unit causes the master unit to return to normal operation, this indicates that the slave unit is malfunctioning. Replace the malfunctioning slave unit.

    OK:
    Master unit returns to normal operation.



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK

REPLACE MALFUNCTIONING PARTS


← AVC-LAN Circuit (Aug 2013 – Jul 2014)Vehicle Speed Signal Circuit between Stereo Component Amplifier and Combination Meter (Aug 2013 – Jul 2014) →