INSTALLATION
Removal / installation · Vehicles built from Aug 2013
| 1. INSTALL SKID CONTROL SENSOR WIRE |
Install the 2 sensor clamps with the 2 bolts.
- Torque:
- 13 N*m{ 127 kgf*cm , 9 ft.*lbf }
- NOTICE:
- Make sure the clamp rotation stopper touches the installation position.
Connect the connector.
- NOTICE:
- Securely connect the connector.
Attach the connector.
Attach the 8 clamps.
- NOTICE:
- When attaching the clamps, do not twist the wire harness.
| 2. INSTALL REAR SPEED SENSOR LH |
Install the speed sensor with the nut.
- Torque:
- 7.8 N*m{ 80 kgf*cm , 69 in.*lbf }
- NOTICE:
- Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.
- While inserting the speed sensor into the axle hole, do not strike or damage the sensor tip.
- After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the axle.
- Make sure there is no foreign matter attached to the speed sensor rotor.
- Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.
Connect the speed sensor connector.
- NOTICE:
- Securely connect the connector.
| 3. INSTALL REAR SPEED SENSOR RH |
- HINT:
- Use the same procedure described for the LH side.
| 4. INSTALL REAR WHEEL |
- Torque:
- for Aluminum Wheel:
- 103 N*m{ 1050 kgf*cm , 76 ft.*lbf }
- for Steel Wheel:
- 112 N*m{ 1137 kgf*cm , 82 ft.*lbf }
| 5. CHECK SPEED SENSOR SIGNAL |
w/o VSC:
Check the speed sensor signal (Click here).
w/ VSC (for hydraulic brake booster):
Check the speed sensor signal (Click here).
w/ VSC (for vacuum brake booster):
Check the speed sensor signal (Click here).
