INSTALLATION
Removal / installation · Vehicles built from Aug 2013
- HINT:
- The procedure listed below is for the LH side.
- Other than areas where instructions are provided, use the same procedures for the RH and LH sides.
- The procedure listed below is for the LH side.
| 1. INSTALL FRONT SPEED SENSOR |
Install the speed sensor with the bolt.
- Torque:
- 8.5 N*m{ 87 kgf*cm , 75 in.*lbf }
- NOTICE:
- Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.
- While inserting the speed sensor into the knuckle hole, do not strike or damage the sensor tip.
- After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the knuckle.
- Make sure there is no foreign matter attached to the speed sensor rotor.
- Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.
| 2. INSTALL SKID CONTROL SENSOR CLAMP |
Install the skid control sensor clamp with the bolt.
- Torque:
- 13 N*m{ 127 kgf*cm , 9 ft.*lbf }
- NOTICE:
- Install the clamp so that the rotation stopper touches the knuckle.
| 3. INSTALL FRONT SKID CONTROL SENSOR WIRE |
Connect the connector as follows.
for LH:
1. Attach the connector, and then connect the connector.- NOTICE:
- Securely connect the connector.
for RH:
1. Install the skid control sensor clamp with the bolt.- Torque:
- 5.0 N*m{ 51 kgf*cm , 44 in.*lbf }
- NOTICE:
- Make sure the clamp rotation stopper touches the installation position.
- NOTICE:
- Securely connect the connector.
- When connecting the connector, do not twist the wire harness.
- Securely connect the connector.
Install the 2 harness clamps with the 2 bolts.
- Torque:
- 13 N*m{ 127 kgf*cm , 9 ft.*lbf }
- NOTICE:
- When installing the clamps, do not twist the wire harness.
- Make sure the clamp rotation stopper touches the installation position.
- When installing the clamps, do not twist the wire harness.
Install the 2 harness clamps with the 2 bolts.
- Torque:
- 13 N*m{ 127 kgf*cm , 9 ft.*lbf }
- NOTICE:
- When installing the clamps, do not twist the wire harness.
- Make sure the clamp rotation stopper touches the installation position.
- When installing the clamps, do not twist the wire harness.
Attach the clip.
Connect the connector.
- NOTICE:
- Securely connect the connector.
| 4. INSTALL FRONT WHEEL |
- Torque:
- for Aluminum Wheel:
- 103 N*m{ 1050 kgf*cm , 76 ft.*lbf }
- for Steel Wheel:
- 112 N*m{ 1137 kgf*cm , 82 ft.*lbf }
| 5. CHECK SPEED SENSOR SIGNAL |
w/o VSC:
Check the speed sensor signal (Click here).
w/ VSC (for hydraulic brake booster):
Check the speed sensor signal (Click here).
w/ VSC (for vacuum brake booster):
Check the speed sensor signal (Click here).
