2013-2015 Land Cruiser Prado · Service Manual Brake

REMOVAL

Removal / installation · Vehicles built from Aug 2013

HINT:
  1. The procedure listed below is for the LH side.
  2. Other than areas where instructions are provided, use the same procedures for the RH and LH sides.


1. REMOVE FRONT WHEEL

2. REMOVE FRONT SKID CONTROL SENSOR WIRE

  1. C212840
    Disconnect the connector from the front speed sensor.

  1. Remove the 2 bolts and 2 harness clamps.

  1. Detach the clip.

  1. C212841
    Remove the 2 bolts and 2 harness clamps.

  1. Disconnect the connector as follows.

    C212843E01

    Text in Illustration 
    *A
    for LH
    *B
    for RH

    1. for LH:

      1. Disconnect the connector.
      2. Detach the connector.

    2. for RH:

      1. Disconnect the connector.
      2. Detach the connector from the skid control sensor clamp.
      3. Detach the clip.
      4. Remove the bolt and skid control sensor clamp.


3. REMOVE SKID CONTROL SENSOR CLAMP

  1. C212842E01
    Remove the bolt and skid control sensor clamp from the knuckle.
    Text in Illustration 
    *A
    for LH
    *B
    for RH


4. REMOVE FRONT SPEED SENSOR
  1. Remove the bolt and speed sensor from the knuckle.

    NOTICE:
    Pull out the sensor while trying as much as possible not to rotate it.

← COMPONENTS (from Aug 2013)INSPECTION (from Aug 2013) →