2013-2015 Land Cruiser Prado · Service Manual Brake

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
*: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.
    NEXT

    3.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
    1. Using the intelligent tester, inspect the CAN communication function to make sure there are no malfunctions in the CAN communication system (for LHD: Click here, for RHD: Click here).

      Result 
      Result
      Proceed to
      DTC is not output
      A
      DTC is output
      B

      HINT:
      The skid control ECU sends the signals of each warning light via CAN communication.


    B.
    A

    4.CHECK DTC AND FREEZE FRAME DATA*
      NEXT

      5.CLEAR DTC AND FREEZE FRAME DATA*
        NEXT

        6.PROBLEM SYMPTOM CONFIRMATION
          NEXT

          7.DTC CHECK AND CLEAR*
            NEXT

            8.PROBLEM SYMPTOM CONFIRMATION
              Result 
              Result
              Proceed to
              Symptom does not occur
              A
              Symptom occurs
              B

            B.
            A

            9.SYMPTOM SIMULATION
              NEXT

              10.CHECK FOR DTC (OTHER THAN CAN COMMUNICATION SYSTEM DTC)*
                Result 
                Result
                Proceed to
                DTC is not output
                A
                DTC is output
                B

              B.
              A

              11.PROBLEM SYMPTOMS TABLE
                NEXT

                12.DTC CHART
                  NEXT

                  13.CIRCUIT INSPECTION*
                    NEXT

                    14.IDENTIFICATION OF PROBLEM
                      NEXT

                      15.REPAIR OR REPLACE
                        NEXT

                        16.CONFIRMATION TEST*
                          NEXT

                          ← HOW TO PROCEED WITH TROUBLESHOOTING (Aug 2013 – Jul 2014)CHECK FOR INTERMITTENT PROBLEMS (from Aug 2013) →