2013-2015 Land Cruiser Prado · Service Manual Brake

DISASSEMBLY

Removal / installation · Vehicles built from Aug 2013

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. REMOVE REAR WHEEL LH

2. DISCONNECT REAR DISC BRAKE CYLINDER ASSEMBLY LH

  1. C214605
    Remove the 2 bolts and disconnect the rear disc brake cylinder.

    NOTICE:
    1. Do not disconnect the flexible hose from the disc brake cylinder.
    2. Do not twist or bend the flexible hose.

  1. Hang the disc brake cylinder with a piece of wire.


3. REMOVE REAR DISC

  1. C215914E01
    Put matchmarks on the rear disc and axle hub if planning to reuse the disc.
    Text in Illustration 
    *1
    Matchmark

  1. D028126E08
    Turn the shoe adjuster until the disc turns freely, and then remove the disc.
    Text in Illustration 
    V100135
    Shoe Adjuster Contracts
    V100136
    Shoe Adjuster Expands


4. REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING

  1. C215936
    Remove the 2 parking brake shoe return tension springs.


5. DISCONNECT NO. 1 PARKING BRAKE SHOE ASSEMBLY LH

  1. C215937
    Remove the parking brake shoe hold down spring cups and parking brake shoe hold down spring to disconnect the No. 1 parking brake shoe assembly from the backing plate.


6. REMOVE PARKING BRAKE SHOE STRUT LH

  1. C215938
    Remove the parking brake shoe strut and parking brake shoe strut compression spring.


7. DISCONNECT NO. 2 PARKING BRAKE SHOE ASSEMBLY LH

  1. C215939
    Remove the parking brake shoe hold down spring cup and parking brake shoe hold down spring to disconnect the No. 2 parking brake shoe assembly from the backing plate.


8. REMOVE PARKING BRAKE SHOE ADJUSTING SCREW SET

  1. C217114
    Remove the parking brake shoe adjusting screw set.


9. REMOVE NO. 1 PARKING BRAKE SHOE ASSEMBLY LH

  1. C215940
    Disconnect the parking brake shoe return tension spring to remove the No. 1 parking brake shoe assembly.


10. REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING

  1. C215941
    Remove the parking brake shoe return tension spring from the No. 2 parking brake shoe assembly.


11. REMOVE NO. 2 PARKING BRAKE SHOE ASSEMBLY WITH PARKING BRAKE SHOE LEVER

  1. C215942
    Using needle-nose pliers, disconnect the No. 3 parking brake cable assembly from the parking brake shoe lever as shown in the illustration.

    NOTICE:
    Be careful not to damage the No. 3 parking brake cable assembly.


12. REMOVE PARKING BRAKE SHOE LEVER LH

  1. C217111
    Remove the C-washer, shim and parking brake shoe lever from the No. 2 parking brake shoe assembly as shown in the illustration.


13. REMOVE PARKING BRAKE SHOE HOLD DOWN SPRING PIN
  1. Remove the parking brake shoe hold down spring pin (for front side).

  1. Remove the parking brake shoe hold down spring pin (for rear side).

← COMPONENTS (from Aug 2013)INSPECTION (from Aug 2013) →