2013-2015 Land Cruiser Prado · Service Manual Suspension

REMOVAL

Removal / installation · Vehicles built from Aug 2013


1. REMOVE FRONT WHEEL

2. REMOVE REAR WHEEL

3. REMOVE SPARE TIRE

4. REMOVE TIRE PRESSURE WARNING VALVE AND TRANSMITTER
  1. Remove the cap and valve core to release the air from the tire.

    NOTICE:
    Keep the removed cap.

  1. After ensuring that a sufficient amount of air has been released, remove the nut and washer used to secure the tire pressure warning valve and transmitter. Then drop the tire pressure warning valve and transmitter with the grommet into the tire.

    HINT:
    The grommet may remain attached to the rim.

  1. C180021E02
    After dropping the tire pressure warning valve and transmitter into the tire, disengage the bead using the shoe of a tire remover.
    Text in Illustration 
    *1
    Tire
    *2
    Shoe

    NOTICE:
    1. Be careful as the tire pressure warning valve and transmitter may become damaged due to interference between the sensor and tire bead.
    2. Set the tire remover shoe as shown in the illustration.

      Width (A):
      10 to 20 mm (0.394 to 0.787 in.)

  1. Separate the upper bead.

  1. Take out the tire pressure warning valve and transmitter with the grommet from the tire and separate the lower bead.

  1. Remove the grommet from the tire pressure warning valve and transmitter.

← COMPONENTS (from Aug 2013)INSTALLATION (Aug 2013 – Jul 2014) →