REMOVAL
Removal / installation · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
- HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
| 1.
REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
|
 |
Remove the tonneau cover.
| 2.
REMOVE MAT SET PLATE COVER
|
 |
- HINT:
- Use the same procedure for all mat set plate covers.
Using a screwdriver, detach the 2 claws and remove the mat set plate cover.
- HINT:
- Tape the screwdriver tip before use.
Text in Illustration
*1
|
Protective tape
|
| 3.
REMOVE REAR FLOOR MAT REAR SUPPORT PLATE
|
 |
Attach the 6 claws to install the rear floor mat rear support plate.
Install the 5 screws.
| 4.
REMOVE QUARTER TRIM COVER HOLE LH
|
 |
Detach the 2 claws and 2 guides and remove the quarter trim cover hole.
| 5.
REMOVE REAR FLOOR CARPET ASSEMBLY
|
 |
Remove the rear floor carpet.
| 6.
REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
|
 |
- HINT:
- Use the same procedure for the other No. 1 luggage compartment trim hook.
Remove the luggage compartment trim hook by turning it clockwise.
| 7.
REMOVE NO. 1 TONNEAU COVER HOLDER CAP (w/o Tonneau Cover)
|
 |
- HINT:
- Use the same procedure for the other tonneau cover holder cap.
Using a screwdriver, detach the 2 claws and remove the tonneau cover holder cap.
- HINT:
- Tape the screwdriver tip before use.
Text in Illustration
*1
|
Protective tape
|
| 8.
REMOVE FRONT DECK SIDE TRIM COVER (w/ Tonneau Cover)
|
 |
- HINT:
- Use the same procedure for the other front deck side trim cover.
Using a screwdriver, detach the 2 claws and remove the front deck side trim cover.
- HINT:
- Tape the screwdriver tip before use.
Text in Illustration
*1
|
Protective tape
|
| 9.
REMOVE OUTER LAP BELT ANCHOR COVER
|
 |
- HINT:
- Use the same procedure for the other outer lap belt anchor cover.
Attach the 3 claws to install the outer lap belt anchor cover.
| 10.
REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH |
 |
- Remove the bolt and disconnect the front seat outer belt floor anchor.
- Remove the bolt and disconnect the rear No. 1 seat outer belt floor anchor.
Remove the 3 bolts and 2 screws.
Detach the 9 claws and 12 clips and remove the deck trim side panel.


| 11.
REMOVE REAR QUARTER TRIM PANEL ASSEMBLY LH
|
 |
Attach the 4 claws and 2 guides and pass the rear No. 1 seat outer belt floor anchor through the rear quarter trim panel.
Attach the 7 clips to install the rear quarter trim panel.
| 12.
REMOVE REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH |
 |
- Remove the bolt and rear No. 1 seat outer belt shoulder anchor.
- Remove the 2 bolts and rear No. 1 seat outer belt assembly.