DATA LIST / ACTIVE TEST
System information · Vehicles built from Aug 2013
| READ DATA LIST |
- HINT:
- Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
- NOTICE:
- In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Warm up the engine.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn ON the intelligent tester.
Enter the following menus: Chassis / Air suspension / Data List.
According to the display on the tester, read the Data List.
Air Suspension Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
(Up & Down) G Sensor FR
(Up & Down) G sensor (Front RH) /
Min.: -1045.29 m/s2
Max.: 1045.26 m/s2
0 +/- 0.98 m/s2 when stationary
The value changes when the vehicle (front RH) is bounced.
(Up & Down) G Sensor FL
(Up & Down) G sensor (Front LH) /
Min.: -1045.29 m/s2
Max.: 1045.26 m/s2
0 +/- 0.98 m/s2 when stationary
The value changes when the vehicle (front LH) is bounced.
(Up & Down) G Sensor Rear
(Up & Down) G sensor (Rear) /
Min.: -1045.29 m/s2
Max.: 1045.26 m/s2
0 +/- 0.98 m/s2 when stationary
The value changes when the vehicle (rear) is bounced.
Gravity Sensor (Side to Side)
Gravity sensor (Side to Side) /
Min.: -1176.37 m/s2
Max.: 1176.33 m/s2
-
-
RR Height Control Sensor
Rear height control sensor RH reading /
Min.: -3276.8 mm (-129 in.)
Max.: 3276.7 mm (129 in.)
-
-
RL Height Control Sensor
Rear height control sensor LH reading /
Min.: -3276.8 mm (-129 in.)
Max.: 3276.7 mm (129 in.)
-
-
Damping Control Switch
Absorber control switch /
NORMAL, COMFORT or SPORT
Indicates current absorber control switch position
-
Stop Light Switch
Stop light switch /
ON or OFF
ON: Brake pedal depressed
OFF: Brake pedal released
-
Door Switch
Door switch /
ON or OFF
ON: Any doors open
OFF: All doors closed
-
Height Control Switch (Up)
Height control switch ("up" side) /
ON or OFF
ON: Switch pressed and held
OFF: Switch not pressed
-
Height Control Switch (Down)
Height control switch ("down" side) /
ON or OFF
ON: Switch pressed and held
OFF: Switch not pressed
-
Height Position
Vehicle height position /
Normal or Not Normal
Normal: Vehicle height position normal
Not Normal: Vehicle height position not normal
-
Height Control
Vehicle height control condition information /
ON or OFF
ON: Vehicle height control operating
OFF: Vehicle height control not operating
-
TD Terminal
TD terminal /
ON or OFF
ON: Height control not operating
OFF: Height control operating
-
TC Terminal
TC terminal /
ON or OFF
OFF
-
TS Terminal
TS terminal /
ON or OFF
OFF
-
L4 Switch
Transfer L4 detection switch /
ON or OFF
ON: Transfer in L4 position
OFF: Transfer not in L4 position
-
IG Power Source Voltage
Actual ECU power supply voltage /
Min.: 0.0 V
Max.: 25.5 V
Ignition switch ON: 11 to 14 V
-
+B Power Source Voltage
Actual battery power supply voltage /
Min.: 0.0 V
Max.: 25.5 V
Ignition switch ON: 11 to 14 V
-
Steering Angle
Steering angle /
Min.: -49152.0 deg
Max.: 49150.5 deg
Actual steering angle
Turned left: reading increases
Turned right: reading decreases
-
Engine Speed
Engine speed value /
Min.: 0 rpm
Max.: 25500 rpm
Actual engine speed
No large fluctuations when the engine speed is constant.
FR Wheel Speed
Front wheel RH speed value /
Min.: 0 km/h (0 mph)
Max.: 255 km/h (158 mph)
Actual vehicle speed
No large fluctuations when the engine speed is constant.
FL Wheel Speed
Front wheel LH speed value /
Min.: 0 km/h (0 mph)
Max.: 255 km/h (158 mph)
Actual vehicle speed
No large fluctuations when the engine speed is constant.
RR Wheel Speed
Rear wheel RH speed value /
Min.: 0 km/h (0 mph)
Max.: 255 km/h (158 mph)
Actual vehicle speed
No large fluctuations when the engine speed is constant.
RL Wheel Speed
Rear wheel LH speed value /
Min.: 0 km/h (0 mph)
Max.: 255 km/h (158 mph)
Actual vehicle speed
No large fluctuations when the engine speed is constant.
Driving Torque
Driving torque /
Min.: -1024 Nm
Max.: 1023 Nm
-
-
Damper Step FR
Damper step (Front RH) /
Min.: 1 step
Max.: 255 step
1 to 16 step
-
Damper Step FL
Damper step (Front LH) /
Min.: 1 step
Max.: 255 step
1 to 16 step
-
Damper Step RR
Damper step (Rear RH) /
Min.: 1 step
Max.: 255 step
1 to 16 step
-
Damper Step RL
Damper step (Rear LH) /
Min.: 1 step
Max.: 255 step
1 to 16 step
-
Max Damper Step FR
Max damper step (Front RH) /
Min.: 0 step
Max.: 255 step
16 step
-
Max Damper Step FL
Max damper step (Front LH) /
Min.: 0 step
Max.: 255 step
16 step
-
Max Damper Step RR
Max damper step (Rear RH) /
Min.: 0 step
Max.: 255 step
16 step
-
Max Damper Step RL
Max damper step (Rear LH) /
Min.: 0 step
Max.: 255 step
16 step
-
Adaptive Variable Suspension (AVS) Mode
Adaptive variable suspension (AVS) mode /
NORMAL, COMFORT, SEMI CO, SEMI SP, SPORTS
Indicates current absorber control switch position
-
Height Mode
Height mode /
NORMAL, ACCE LO, LO, STAN LO, FAST LO, L4 HI, HI, EX HI or LUGG LO
NORMAL: Height control N mode
LO: Height control LO mode
HI: Height control HI mode
-
Height Control Prohibition
Height control prohibition /
Permiss or Prohibi
Permiss: Height control permitted
Prohibi: Height control prohibited
-
Rear Gate Solenoid
Status of rear gate solenoid /
ON or OFF
ON: Gate solenoid operated
OFF: Gate solenoid not operated
-
Rear Leveling Solenoid
Status of rear leveling solenoid /
ON or OFF
ON: Leveling solenoid operated
OFF: Leveling solenoid not operated
-
Exhaust Solenoid
Status of the exhaust solenoid /
ON or OFF
ON: Exhaust solenoid valve operated
OFF: Exhaust solenoid valve not operated
-
Motor Relay
Status of the motor relay /
ON or OFF
ON: Compressor operated
OFF: Compressor not operated
-
Main Relay
Status of the main relay /
ON or OFF
ON: Main relay on (Ignition switch ON)
OFF: Main relay off
-
Compatible Constant Information
Compatible constant information /
Min.: 0
Max.: 255
-
-
Identical Constant Information
Identical constant information /
Min.: 0
Max.: 255
-
-
Design Constant Information
Vehicle identification information number /
Min.: 0
Max.: 255
-
-
Number of Trouble Codes
Number of DTCs stored /
Min.: 0
Max.: 255
0
-
| PERFORM ACTIVE TEST |
- HINT:
- Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Warm up the engine.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn ON the intelligent tester.
Enter the following menus: Chassis / Air suspension / Active Test.
According to the display on the tester, perform the Active Test.
Air Suspension Tester Display
Test Part
Control Range
Diagnostic Note
Damper Step FR
Changes damper step (Front RH)
1 to 16 step
The shock absorber hardens as the damper step increases.
Damper Step FL
Changes damper step (Front LH)
1 to 16 step
The shock absorber hardens as the damper step increases.
Damper Step RR
Changes damper step (Rear RH)
1 to 16 step
The shock absorber hardens as the damper step increases.
Damper Step RL
Changes damper step (Rear LH)
1 to 16 step
The shock absorber hardens as the damper step increases.
Rear Wheel Up/Down
Rear vehicle height
OFF, Up or Down
-
Rear Gate Solenoid
Gate solenoid valve
ON or OFF
- The operating sound of the solenoid (clicking sound) can be heard.
- When the Active Test is performed, Rear Gate Solenoid in the Data List changes between ON and OFF accordingly.
Rear Leveling Solenoid
Leveling solenoid valve
ON or OFF
- The operating sound of the solenoid (clicking sound) can be heard.
- When the Active Test is performed, Rear Leveling Solenoid in the Data List changes between ON and OFF accordingly.
Exhaust Solenoid
Exhaust solenoid valve
ON or OFF
- The operating sound of the solenoid (clicking sound) can be heard.
- When the Active Test is performed, Exhaust Solenoid in the Data List changes between ON and OFF accordingly.
Compressor Motor Relay
AIR SUS relay
ON or OFF
- The operating sound of the relay (clicking sound) can be heard.
- When the Active Test is performed, Compressor Motor Relay in the Data List changes between ON and OFF accordingly.
- The operating sound of the solenoid (clicking sound) can be heard.