ON-VEHICLE INSPECTION
Inspection · Vehicles built from Aug 2013
| INSPECT GLOW PLUG |
 |
- NOTICE:
- Turn the ignition switch off for 60 seconds before performing this inspection.
- Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
Glow plug terminal - Body ground
|
20°C (68°F)
|
Approximately 1.0 Ω
|
- NOTICE:
- Do not damage the glow plug pipes as doing so could cause an open circuit or shorten the life of the glow plugs.
- Prevent oil and gasoline from contacting the glow plugs when cleaning them.
- During the inspection, be sure to wipe off any oil on the terminal and Bakelite washer with a dry cloth.
- Do not apply more than 11 V to the glow plug as it could cause an open circuit.