ON-VEHICLE INSPECTION
Inspection · Vehicles built from Aug 2013
| CHECK DRIVE BELT TENSION |
Visually check the belt for cracks, oiliness or wear. Check that the belt does not touch the bottom of the pulley groove.

If necessary, replace the belt.Text in Illustration *a
Clearance
*b
Correct
*c
Incorrect
Check the drive belt deflection by pressing on the belt at the point indicated in the illustration with 98 N (10 kgf, 22 lbf) of force.

Text in Illustration *a
Crankshaft Pulley
*b
Vane Pump Pulley


Measuring Point for Belt Deflection
- Standard Drive Belt Deflection:
Item
Specified Condition
New belt
8.0 to 10 mm
(0.315 to 0.393 in.)
Used belt
10 to 15 mm
(0.394 to 0.590 in.)
Using a belt tension gauge, check the drive belt tension.
- Standard Drive Belt Tension:
Item
Specified Condition
New belt
441 to 539 N
(45 to 55 kgf, 99.2 to 121 lbf)
Used belt
196 to 343 N
(20 to 35 kgf, 44.1 to 77.1 lbf)
- If the belt tension is not as specified, adjust it.
