2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT MASS AIR FLOW METER

  1. Check the output voltage.

    1. A227197E01
      Apply battery voltage across terminals 1 (+B) and 2 (E2G).

      NOTICE:
      While using the battery during inspection, do not bring the positive (+) and negative (-) tester probes too close to each other as a short circuit may occur.

    2. Using a voltmeter, connect the positive (+) tester probe to terminal 3 (VG) and the negative (-) tester probe to terminal 2 (E2G).

    3. Blow air into the mass air flow meter and check that the voltage fluctuates.

      Text in Illustration 
      V100135
      Air
      If the result is not as specified, replace the mass air flow meter.

  1. A165595E03
    Perform a visual check for any foreign matter on the platinum hot wire (heater) of the mass air flow meter shown in the illustration.

    OK:
    There is no foreign matter.

    Text in Illustration 
    *1
    Platinum Hot Wire (Heater)
    If the result is not as specified, replace the mass air flow meter.

  1. Check the intake air temperature sensor.

    A165586E07

    Text in Illustration 
    *1
    Resistance
    *2
    Temperature
    *3
    Acceptable
    -
    -
    *a
    Component without harness connected
    (Mass Air Flow Meter)
    -
    -

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      4 (THA) - 5 (E2)
      -20°C (-4°F)
      12.5 to 16.9 kΩ
      20°C (68°F)
      2.19 to 2.67 kΩ
      60°C (140°F)
      0.50 to 0.68 kΩ

      If the result is not as specified, replace the mass air flow meter.

← REMOVAL (from Aug 2013)INSTALLATION (from Aug 2013) →