REPAIR
Removal / installation · Vehicles built from Aug 2013
| 1. REPAIR DEFOGGER WIRE |
![]() ![]() |
Clean the broken wire tips with grease, wax and silicone remover.
Place masking tape along both sides of the wire.
Thoroughly mix the repair agent.
- DuPont paste:
- No. 4817 or equivalent
Text in Illustration *a
Repair Point
*b
Masking Tape
*c
Broken Wire
Using a fine tip brush, apply a small amount of the agent to the wire.

Text in Illustration *a
Fine Tip Brush
*b
Repair Point
After a few minutes, remove the masking tape.
- NOTICE:
- Do not allow electricity to flow in the defogger wire for at least 24 hours.

