2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

REASSEMBLY

Removal / installation · Vehicles built from Aug 2013


1. INSTALL NOZZLE RETAINING NUT

  1. FU01353E04
    Install the pressure pin, distance piece and nozzle assembly to the nozzle retaining nut.

  1. Install the nozzle holder pressure spring and adjusting shim, and then temporarily install the nozzle holder to the nozzle retaining nut.

  1. Using SST, tighten the nozzle retaining nut.

    SST
    09268-64010   (09268-64020, 09268-64030)

    Torque:
    47 N*m{ 475 kgf*cm , 34 ft.*lbf }

    NOTICE:
    Overtightening could cause nozzle deformation and needle adhesion or other defects.

  1. Inspect the holder and nozzle set.


2. INSTALL RING PACKING SETTING NUT
  1. Install a new washer and the ring packing setting nut.

← INSPECTION (from Aug 2013)INSTALLATION (Aug 2013 – Jul 2014) →