Component
|
Function
|
Absorber Control Switch
|
Selects the damping force of the shock absorbers (SPORT, normal, COMF).
|
Acceleration Sensor
|
Detects the front right or left body vertical accelerated motions.
|
Absorber Control Actuator
|
Changes the damping force of the front shock absorber.
|
Height Control OFF Switch
|
Used to operate or stop height control.
|
Height Control Switch
|
Used to select the vehicle height.
|
Height Control Sensor
|
Convert vertical changes in the rear vehicle height, in proportion to the standard, to signals and detects vehicle height.
|
Height Control Indicator
|
Displays the current vehicle height (HI, N, LO).
|
Height Control OFF Indicator
|
Comes on during height control OFF mode.
|
Height Control Compressor
|
Generates compressed air that is necessary to raise vehicle height and supplies it to the pneumatic cylinder assemblies.
|
Exhaust Solenoid Valve (Height Control Compressor)
|
Discharges compressed air from the pneumatic cylinder assemblies to lower the vehicle.
|
Leveling Solenoid Valve (No. 2 Height Control Valve)
|
Adjusts the air pressure in the pneumatic cylinder assembly to raise or lower the vehicle height.
|
Gate Solenoid Valve (No. 2 Height Control Valve)
|
Opens or closes the passage between the pneumatic cylinder assembly LH and RH.
|
Suspension Control ECU
|
- Estimates the vehicle condition based on the signals from sensors and switches and outputs control signals to the compressor and valves.
- When changed to the diagnostic mode, indicates any malfunction by outputting DTCs.
- Detects the front left body vertical accelerated motion.
|
Suspension Control Relay (AIR SUS)
|
Supplies electricity to the compressor motor.
|
Main Body ECU
|
Receives signals from the door courtesy light switches and sends them to the suspension control ECU through CAN communication.
|
ECM
|
Sends the engine speed signal to the suspension control ECU through CAN communication.
|
Skid Control ECU
|
Receives signals from the stop light switch and speed sensors and sends them to the suspension control ECU through CAN communication.
|