U0101 Lost Communication with TCM
Diagnostic trouble codes · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The ECM (engine control unit) communicates with the TCM (transmission control ECU) through the Controller Area Network (CAN).If there is a problem with this communication, the ECM stores a DTC.
| DTC Detection Drive Pattern |
DTC Detection Condition |
Trouble Area |
| Ignition switch ON for 3 seconds |
Both conditions are met for 1.25 seconds (1 trip detection logic):
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK FOR ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC U0101) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
Result Result
Proceed to
DTC U0101 is output
A
DTC U0101 and other DTCs are output
B
- HINT:
- If any DTCs other than U0101 are output, troubleshoot those DTCs first.
|
|
||||
| A | |
| 2. INSPECT TCM POWER SOURCE CIRCUIT (POWER SOURCE AND BODY GROUND) |
Disconnect the TCM connector.

Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
G70-5 (BATT) - G69-1 (E1)
Ignition switch ON
11 to 14 V
Text in Illustration *a
Rear view of wire harness connector
(to TCM)
Reconnect the TCM connector.
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (ECM - TCM) |
Disconnect the TCM connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
C92-24 (CAN+) - G70-21 (CAN+)
Always
Below 1 Ω
C92-18 (CAN-) - G70-20 (CAN-)
Always
Below 1 Ω
C92-24 (CAN+) or G70-21 (CAN+) - Body ground or other terminals
Always
1 MΩ or higher
C92-18 (CAN-) or G70-20 (CAN-) - Body ground or other terminals
Always
1 MΩ or higher
Reconnect the TCM connector.
Reconnect the ECM connector.
|
|
||||
| OK | |
| 4. REPLACE ECM |
Replace the ECM (Click here).
| NEXT | |
| 5. CHECK WHETHER DTC OUTPUT RECURS (DTC U0101) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
Result Result
Proceed to
DTC is not output
A
DTC U0101 is output
B
|
|
||||
| A | ||
| ||
