2013-2015 Land Cruiser Prado · Service Manual Power Source / Network

INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT GENERATOR WITH CLUTCH PULLEY

  1. A222451
    Hold the center of the generator with clutch pulley and check that the outer ring turns counterclockwise and does not turn clockwise.
    Text in Illustration 
    V100135
    Free
    V100136
    Lock
    If the result is not as specified, replace the generator with clutch pulley.


INSPECT GENERATOR BRUSH HOLDER ASSEMBLY

  1. A128079E19
    Using a vernier caliper, measure the brush length.

    Standard exposed length:
    9.5 to 11.5 mm (0.374 to 0.453 in.)

    Minimum exposed length:
    4.5 mm (0.177 in.)

    Text in Illustration 
    *a
    Length
    If the brush length is less than the minimum, replace the generator brush holder assembly.


INSPECT GENERATOR ROTOR ASSEMBLY

  1. A079306E02
    Check that the generator rotor bearing is not rough or worn.
    If necessary, replace the generator rotor assembly.

  1. Check the generator rotor for an open circuit.

    1. B012264E39
      Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      for 100 A (w/o Dual Air Conditioning System), 130 A Type: 
      Tester Connection
      Condition
      Specified Condition
      Slip ring - Slip ring
      20°C (68°F)
      2.3 to 2.7 Ω
      for 100 A (w/ Dual Air Conditioning System) Type: 
      Tester Connection
      Condition
      Specified Condition
      Slip ring - Slip ring
      20°C (68°F)
      3.4 to 3.8 Ω
      for 150 A Type: 
      Tester Connection
      Condition
      Specified Condition
      Slip ring - Slip ring
      20°C (68°F)
      1.5 to 1.9 Ω

      Text in Illustration 
      *a
      Slip Ring
      If the result is not as specified, replace the generator rotor assembly.

  1. Check if the generator rotor is grounded.

    1. B012265E34
      Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      Slip ring - Rotor core
      Always
      10 MΩ or higher

      Text in Illustration 
      *a
      Slip Ring
      *b
      Rotor Core
      If the result is not as specified, replace the generator rotor assembly.

  1. A124106E09
    Using a vernier caliper, measure the slip ring diameter.

    Standard diameter:
    14.2 to 14.8 mm (0.559 to 0.583 in.)

    Minimum diameter:
    14.0 mm (0.551 in.)

    Text in Illustration 
    *a
    Diameter
    If the diameter is less than the minimum, replace the generator rotor assembly.

← DISASSEMBLY (from Aug 2013)REASSEMBLY (from Aug 2013) →