2013-2015 Land Cruiser Prado · Service Manual Brake

REMOVAL

Removal / installation · Vehicles built from Aug 2013

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. REMOVE FRONT WHEEL

2. DRAIN BRAKE FLUID

NOTICE:
Wash off the brake fluid immediately if it comes into contact with a painted surface.


3. REMOVE FRONT DISC BRAKE PAD

  1. C215909E04
    Remove the pin hold clip.
    Text in Illustration 
    *1
    Hole Pin
    *2
    Pin Hold Clip
    *3
    Anti-rattle Spring

    NOTICE:
    The pin hold clip can be reused if it has sufficient rebound; no deformation or wear; and has had all rust, dirt and foreign matter cleaned off.

  1. Remove the 2 hole pins.

  1. C170925
    Remove the front disc brake anti-rattle spring.

    NOTICE:
    The anti-rattle spring can be reused if it has sufficient rebound; no deformation, cracks or wear; and has had all rust, dirt and foreign matter cleaned off.

  1. C170926
    Remove the 2 front disc brake pads from the disc brake cylinder.

  1. Remove the front No. 1 anti-squeal shims from each pad.


4. REMOVE DISC BRAKE CYLINDER ASSEMBLY LH

  1. F043120
    Using a union nut wrench, disconnect the brake tube from the disc brake cylinder assembly.

    HINT:
    Use a container to catch brake fluid as it drains out.

  1. F043121
    Remove the 2 bolts and disc brake cylinder assembly.


5. REMOVE FRONT DISC

  1. C215913E01
    Place matchmarks on the disc and axle hub if planning to reuse the disc.
    Text in Illustration 
    *1
    Matchmark

  1. Remove the front disc.

← COMPONENTS (from Aug 2013)DISASSEMBLY (from Aug 2013) →