2013-2015 Land Cruiser Prado · Service Manual Power Source / Network

ECM Communication Stop Mode

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

Detection Item
Symptom
Trouble Area
ECM Communication Stop Mode
Either condition is met:
  1. "ECM (Engine)" is not displayed on "Bus Check".
  2. "ECM Communication Stop Mode" in "DTC Combination Table" applies.
  1. Power source or inside ECM
  2. ECM
  1. For vehicles with a 1KD-FTV engine only.

WIRING DIAGRAM

C289503E02

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. CHECK HARNESS AND CONNECTOR (ECM - BATTERY AND BODY GROUND)

  1. Disconnect the C93, G57 and G58 ECM connectors.C289505E01

Text in Illustration 
*a
Front view of wire harness connector
(to ECM)
-
-
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    C93-1 (E1) - Body ground
    Always
    Below 1 Ω
    C93-8 (ME01) - Body ground
    Always
    Below 1 Ω
    C93-12 (E01) - Body ground
    Always
    Below 1 Ω
    C93-13 (E02) - Body ground
    Always
    Below 1 Ω
    G57-11 (EC) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    G57-23 (BATT) - Body ground
    Always
    11 to 14 V
    G57-24 (+B) - Body ground
    Battery positive (+) voltage applied to terminal G58-11 (MREL)
    11 to 14 V
    G57-17 (+B2) - Body ground
    Battery positive (+) voltage applied to terminal G58-11 (MREL)
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM (Click here)


← ECM Communication Stop Mode (Aug 2013 – Jul 2014)Main Body ECU Communication Stop Mode (Aug 2013 – Jul 2014) →