2013-2015 Land Cruiser Prado · Service Manual Steering

TERMINALS OF ECU

System information · Vehicles built from Aug 2013


CHECK STEERING LOCK ECU
C104383E20
  1. Disconnect the G35 steering lock ECU connector.

  2. Measure the voltage and resistance according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    G35-1 (GND) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    G35-6 (IG2) - G35-1 (GND)
    W - W-B
    IG2 signal input
    Engine switch off → engine switch on (IG)
    Below 1 V → 11 to 14 V
    G35-7 (B) - G35-1 (GND)
    G - W-B
    Power source
    Always
    11 to 14 V
    If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the G35 steering lock ECU connector.

  4. Measure the voltage according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    G35-3 (IGE) - G35-1 (GND)
    W - W-B
    Power source for motor drive
    When all conditions are met:
    1. Steering lock unlocked
    2. Engine switch off
    3. Shift lever in P*
    4. Driver side door closed → opened
    11 to 14 V (Steering lock motor not operating) → Below 1 V (Steering lock motor operating) → 11 to 14 V (Steering lock motor not operating)
    G35-4 (SLP1) - G35-1 (GND)
    SB - W-B
    Unlock position sensor output signal
    Steering lock locked → steering lock unlocked
    11 to 14 V → Below 1.2 V
    *: for Automatic Transmission
    If the result is not as specified, there may be a malfunction in the steering lock ECU.

← PROBLEM SYMPTOMS TABLE (from Aug 2014)DIAGNOSIS SYSTEM (from Aug 2013) →