2013-2015 Land Cruiser Prado · Service Manual Power Source / Network

Combination Meter ECU Communication Stop Mode

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

Detection Item
Symptom
Trouble Area
Combination Meter ECU Communication Stop Mode
Either condition is met:
  1. "Combination Meter" is not displayed on "Bus Check".
  2. "Combination Meter ECU Communication Stop Mode" in "DTC Combination Table" applies.
  1. Power source or inside combination meter assembly
  2. Combination meter assembly

WIRING DIAGRAM

C175530E18

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. CHECK HARNESS AND CONNECTOR (COMBINATION METER - BATTERY AND BODY GROUND)

  1. C198950E22
    Disconnect the G6 combination meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G6-21 (E2) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    G6-26 (B) - Body ground
    Always
    11 to 14 V
    G6-28 (IG+) - Body ground
    Engine switch on (IG)
    11 to 14 V

Text in Illustration 
*a
Front view of wire harness connector
(to Combination Meter Assembly)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)


← Combination Meter ECU Communication Stop Mode (Aug 2013 – Jul 2014)Certification ECU Communication Stop Mode (Aug 2013 – Jul 2014) →