2013-2015 Land Cruiser Prado · Service Manual Suspension

INSTALLATION

Removal / installation · Vehicles built from Aug 2013


1. INSTALL REAR STABILIZER BAR

  1. D028261E03
    Install the 2 stabilizer bushes to the stabilizer bar.

    HINT:
    Install the stabilizer bush to the outer side of the stabilizer bush stopper on the stabilizer bar.

    Text in Illustration 
    V100136
    Outer Side

  1. Install the stabilizer bar and 2 stabilizer brackets with the 4 bolts.

    Torque:
    45 N*m{ 459 kgf*cm , 33 ft.*lbf }


2. INSTALL REAR STABILIZER LINK ASSEMBLY LH
  1. Install the stabilizer link with a new nut.

    Torque:
    70 N*m{ 714 kgf*cm , 52 ft.*lbf }

    HINT:
    If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.

  1. Install the 2 retainers and cushion to the stabilizer link.

  1. Hold the stabilizer bar link with a wrench, and then install the retainer, cushion and link with a new nut.

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf }


3. INSTALL REAR STABILIZER LINK ASSEMBLY RH

HINT:
Use the same procedure described for the LH side.


4. INSTALL REAR WHEEL

Torque:
112 N*m{ 1142 kgf*cm , 83 ft.*lbf }

← INSPECTION (from Aug 2013)PRECAUTION (from Aug 2013) →