2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

Data Signal Circuit between Radio Receiver and Stereo Jack Adapter

Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a device to the radio and display receiver assembly via this circuit.

WIRING DIAGRAM

E280107E10

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
  1. Disconnect the H69 radio and display receiver assembly connector.

  1. Disconnect the H68 No. 1 stereo jack adapter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H69-2 (UDO-) - H68-2 (UDO-)
    Always
    Below 1 Ω
    H69-3 (UDO+) - H68-3 (UDO+)
    Always
    Below 1 Ω
    H69-2 (UDO-) - Body ground
    Always
    10 kΩ or higher
    H69-3 (UDO+) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter (from Aug 2014)Data Signal Circuit between Radio Receiver and Stereo Jack Adapter (from Aug 2014) →