2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

Power Source Circuit

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

Power is supplied to the fold seat control ECU through the ECU-B, FOLD SEAT LH*1, FOLD SEAT RH*2 and ECU-IG NO. 2 fuses.
  1. *1: for LH Side
  2. *2: for RH Side

WIRING DIAGRAM

B239511E01

INSPECTION PROCEDURE

HINT:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. CHECK HARNESS AND CONNECTOR (FOLD SEAT CONTROL ECU - BATTERY AND BODY GROUND)

  1. B242089E01
    for LH Side:Disconnect the d1 and d2 ECU connectors.

  1. for RH Side:Disconnect the c1 and c2 ECU connectors.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    for LH Side 
    Tester Connection
    Condition
    Specified Condition
    d2-2 (+B) - Body ground
    Always
    11 to 14 V
    d1-1 (ECUB) - Body ground
    Always
    11 to 14 V
    d1-3 (IG) - Body ground
    Ignition switch off
    Below 1 V
    Ignition switch ON
    11 to 14 V
    for RH Side 
    Tester Connection
    Condition
    Specified Condition
    c2-2 (+B) - Body ground
    Always
    11 to 14 V
    c1-1 (ECUB) - Body ground
    Always
    11 to 14 V
    c1-3 (IG) - Body ground
    Ignition switch off
    Below 1 V
    Ignition switch ON
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for LH Side 
    Tester Connection
    Condition
    Specified Condition
    d2-10 (GND) - Body ground
    Always
    Below 1 Ω
    d2-9 (GND2) - Body ground
    Always
    Below 1 Ω
    for RH Side 
    Tester Connection
    Condition
    Specified Condition
    c2-10 (GND) - Body ground
    Always
    Below 1 Ω
    c2-9 (GND2) - Body ground
    Always
    Below 1 Ω

Text in Illustration 
*A
for LHD
*B
for RHD
*a
Front view of wire harness connector
(to Fold Seat Control ECU)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Power Source Circuit (Aug 2013 – Jul 2014)Fold Seat Switch Circuit (Aug 2013 – Jul 2014) →