Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter
Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
- *1: for 9 Speakers
- *2: for 6 Speakers
The sound signal that has been sent is amplified by the stereo component amplifier assembly*1 or radio and display receiver assembly*2, and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly*1, radio and display receiver assembly*2 or speakers.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (NO. 1 STEREO JACK ADAPTER ASSEMBLY - RADIO AND DISPLAY RECEIVER ASSEMBLY) |
Disconnect the H68 No. 1 stereo jack adapter assembly connector.
Disconnect the H51 radio and display receiver assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
H68-8 (VAL+) - H51-28 (VAL+)
Always
Below 1 Ω
H68-7 (VAR+) - H51-26 (VAR+)
Always
Below 1 Ω
H68-9 (VA-) - H51-27 (VA-)
Always
Below 1 Ω
H68-12 (AGND) - H51-11 (AGND)
Always
Below 1 Ω
H68-10 (ADPG) - H51-25 (ADPG)
Always
Below 1 Ω
H51-12 (SG) - Body ground
Always
Below 1 Ω
H68-8 (VAL+) - Body ground
Always
10 kΩ or higher
H68-7 (VAR+) - Body ground
Always
10 kΩ or higher
H68-9 (VA-) - Body ground
Always
10 kΩ or higher
H68-12 (AGND) - Body ground
Always
10 kΩ or higher
H68-10 (ADPG) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
