2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT AIR CONDITIONING PRESSURE SWITCH (for Single Air Conditioning System)

  1. I033643E02
    Install a manifold gauge set.
    Text in Illustration 
    *a
    Component without harness connected
    (Air Conditioning Pressure Switch)
    *b
    Low Pressure Side
    *c
    On (Below 1.0 Ω)
    *d
    High Pressure Side
    *e
    Off (10 kΩ or higher)

  1. Connect the positive (+) lead from the ohmmeter to terminal 1 and the negative (-) lead to terminal 2.

  1. Check the resistance between terminals when refrigerant pressure is charged as shown in the illustration.
    If operation is not as specified, replace the air conditioning pressure switch.


INSPECT AIR CONDITIONING PRESSURE SWITCH (for Dual Air Conditioning System)
  1. Install a manifold gauge set.

  1. Disconnect the connector from the air conditioning pressure switch.

  1. E183932E02
    Connect the positive (+) lead of a DC 5 V power source to terminal 3 and the negative (-) lead to terminal 1.

  1. Connect the positive (+) lead of the voltmeter to terminal 2 and the negative (-) lead to terminal 1.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    2 (PR) - 1 (-)
    Refrigerant pressure:
    0.39 to 3.187 MPa (57 to 463 psi)
    0.93 to 4.9 V

    Text in Illustration 
    *a
    Component without harness connected
    (Air Conditioning Pressure Switch)
    *b
    Voltage
    *c
    Refrigerant Pressure
    If the result is not as specified, replace the air conditioning pressure switch.

← COMPONENTS (from Aug 2013)REMOVAL (from Aug 2013) →