2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

Sound Signal Circuit between Navigation Receiver Assembly and Stereo Component Amplifier

Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The navigation receiver assembly sends a sound signal to the stereo component amplifier assembly via this circuit.
The sound signal that has been sent is amplified by the stereo component amplifier assembly, and then is sent to the speakers.

WIRING DIAGRAM

E286236E02

INSPECTION PROCEDURE

HINT:
When replacing the navigation receiver assembly, it is necessary to perform the vehicle contract setting for Connected Services (w/ Connected Services Function).


1. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY)
  1. Disconnect the H54 navigation receiver assembly connector.

  1. Disconnect the H63 stereo component amplifier assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H54-6 (FL-) - H63-2 (L-)
    Always
    Below 1 Ω
    H54-2 (FL+) - H63-3 (L+)
    Always
    Below 1 Ω
    H54-5 (FR-) - H63-4 (R-)
    Always
    Below 1 Ω
    H54-1 (FR+) - H63-5 (R+)
    Always
    Below 1 Ω
    H54-6 (FL-) - Body ground
    Always
    10 kΩ or higher
    H54-2 (FL+) - Body ground
    Always
    10 kΩ or higher
    H54-5 (FR-) - Body ground
    Always
    10 kΩ or higher
    H54-1 (FR+) - Body ground
    Always
    10 kΩ or higher
    H63-6 (SLD) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Speaker Circuit (from Aug 2014)Sound Signal Circuit between Navigation Receiver Assembly and Stereo Component Amplifier (from Aug 2014) →