Sound Signal Circuit between Navigation Receiver Assembly and Stereo Component Amplifier
Circuit diagnosis · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The navigation receiver assembly sends a sound signal to the stereo component amplifier assembly via this circuit.The sound signal that has been sent is amplified by the stereo component amplifier assembly, and then is sent to the speakers.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY) |
Disconnect the H60 navigation receiver assembly connector.
Disconnect the H63 stereo component amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
H60-6 (FL-) - H63-2 (L-)
Always
Below 1 Ω
H60-2 (FL+) - H63-3 (L+)
Always
Below 1 Ω
H60-5 (FR-) - H63-4 (R-)
Always
Below 1 Ω
H60-1 (FR+) - H63-5 (R+)
Always
Below 1 Ω
H60-6 (FL-) - Body ground
Always
10 kΩ or higher
H60-2 (FL+) - Body ground
Always
10 kΩ or higher
H60-5 (FR-) - Body ground
Always
10 kΩ or higher
H60-1 (FR+) - Body ground
Always
10 kΩ or higher
H63-6 (SLD) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
