2013-2015 Land Cruiser Prado · Service Manual Drivetrain

DISASSEMBLY

Removal / installation · Vehicles built from Aug 2013


1. REMOVE FRONT UNIVERSAL JOINT SPIDER BEARING

HINT:
Use the same procedure for all front propeller shaft universal joint spider bearing.

  1. F015023E10
    Place matchmarks on the flange yoke and sleeve yoke.
    Text in Illustration 
    *a
    Matchmark

  1. C061264
    Using a brass bar and hammer, slightly tap in the spider bearing outer races.

  1. Using 2 screwdrivers, remove the 4 snap rings from the grooves.

  1. F015025E08
    Using SST, remove the spider bearing from the propeller shaft.
    SST
    09332-25010  

    HINT:
    Before installing SST, sufficiently raise the part labeled A. If the part labeled A is too low, it may be difficult to install SST.

  1. F044192E08
    Clamp the spider bearing outer race in a vise between aluminum plates and tap off the propeller shaft with a hammer.
    Text in Illustration 
    *a
    Hammering Point

    HINT:
    Remove the bearing on the opposite side using the same procedure.

    NOTICE:
    Do not tap the shaft.

  1. F015030E11
    Install the 2 removed spider bearing outer races to the universal joint spider.

  1. Using SST, remove the bearing from the yoke.

    SST
    09332-25010  

    HINT:
    Before installing SST, sufficiently raise the part labeled A. If the part labeled A is too low, it may be difficult to install SST.

  1. F044193E09
    Clamp the outer bearing race in a vise between aluminum plates and tap off the flange yoke with a hammer.
    Text in Illustration 
    *a
    Hammering Point

  1. Remove the universal joint spider.

← REMOVAL (from Aug 2013)INSPECTION (from Aug 2013) →