Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM (w/o Multi-display)
Rear Clearance Sonar Sensor LH Circuit
Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The ultrasonic sensor sends and receives ultrasonic waves. Based on the received wave, the sensor calculates the approximate distance between the vehicle and obstacle and sends the distance value as a signal to the clearance warning ECU. WIRING DIAGRAM
INSPECTION PROCEDURE
1. INSPECT NO. 1 ULTRASONIC SENSOR (REAR CORNER SENSOR LH)
Remove the No. 1 ultrasonic sensor (rear corner sensor LH) (Click here ).
Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
Specified Condition
1 (BI) - 5 (EI)
Always
10 kΩ or higher
1 (BI) - 2 (BO)
Always
10 kΩ or higher
3 (SI) - 4 (SO)
Always
Below 1 Ω
5 (EI) - 6 (EO)
Always
Below 1 Ω
NG
REPLACE NO. 1 ULTRASONIC SENSOR (REAR CORNER SENSOR LH) (Click here )
OK
2. CHECK HARNESS AND CONNECTOR (REAR CORNER SENSOR LH - CLEARANCE WARNING ECU)
Disconnect the V5 No. 1 ultrasonic sensor (rear corner sensor LH) connector.
Disconnect the I1 clearance warning ECU connector.
Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
Specified Condition
V5-1 (BI) - I1-24 (BOR)
Always
Below 1 Ω
V5-3 (SI) - I1-6 (SOR)
Always
Below 1 Ω
V5-5 (EI) - I1-22 (E2)
Always
Below 1 Ω
V5-1 (BI) - Body ground
Always
10 kΩ or higher
V5-3 (SI) - Body ground
Always
10 kΩ or higher
V5-5 (EI) - Body ground
Always
10 kΩ or higher
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here )