2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

Rear Clearance Sonar Sensor RH Circuit

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The ultrasonic sensor sends and receives ultrasonic waves. Based on the received wave, the sensor calculates the approximate distance between the vehicle and obstacle and sends the distance value as a signal to the clearance warning ECU.

WIRING DIAGRAM

E132021E35

INSPECTION PROCEDURE


1. REPLACE NO. 1 ULTRASONIC SENSOR (REAR CORNER SENSOR RH)
  1. Replace the No. 1 ultrasonic sensor with a normally functioning sensor (Click here).


NEXT


2. CHECK HARNESS AND CONNECTOR (REAR CORNER SENSOR RH - REAR CENTER SENSOR RH)
  1. Disconnect the U5 No. 1 clearance sensor (rear corner sensor RH) connector.

  1. Disconnect the U4 No. 1 clearance sensor (rear center sensor RH) connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    U5-1 (BI) - U4-2 (BO)
    Always
    Below 1 Ω
    U5-3 (SI) - U4-4 (SO)
    Always
    Below 1 Ω
    U5-5 (EI) - U4-6 (EO)
    Always
    Below 1 Ω
    U5-1 (BI) - Body ground
    Always
    10 kΩ or higher
    U5-3 (SI) - Body ground
    Always
    10 kΩ or higher
    U5-5 (EI) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Rear Clearance Sonar Sensor RH Circuit (Aug 2013 – Jul 2014)Clearance Sonar Main Switch Circuit (Aug 2013 – Jul 2014) →