Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014from Aug 2014
DESCRIPTION
The ultrasonic sensor sends and receives ultrasonic waves. Based on the received wave, the sensor calculates the approximate distance between the vehicle and obstacle and sends the distance value as a signal to the clearance warning ECU.
WIRING DIAGRAM
INSPECTION PROCEDURE
1. INSPECT NO. 1 ULTRASONIC SENSOR (REAR CENTER SENSOR RH)
Remove the No. 1 ultrasonic sensor (rear center sensor RH) (Click here).
Measure the resistance according to the value(s) in the table below.