REMOVAL
Removal / installation · Vehicles built from Aug 2013
| 1. SUPPORT TRANSMISSION AND TRANSFER ASSEMBLY (w/ DPF) |
Support the transmission and transfer with a transmission jack.
- NOTICE:
- For safety reasons, install the No. 3 frame crossmember after removing the front exhaust pipe.
| 2. REMOVE FRONT SUSPENSION MEMBER BRACKET LH AND RH (w/ DPF) |
Remove the 8 bolts, front suspension member bracket LH and RH.

| 3. REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY (w/ DPF) |
Remove the 4 bolts of the rear engine mounting insulator.

Remove the 4 nuts, 4 bolts and frame crossmember.

| 4. DISCONNECT AIR FUEL RATIO SENSOR (w/ DPF) |
Disconnect the air fuel ratio sensor connector and detach the clamp.

| 5. DISCONNECT CENTER EXHAUST PIPE ASSEMBLY (w/ DPF) |
Remove the 2 bolts and 2 compression springs, and then disconnect the center exhaust pipe.

| 6. REMOVE FRONT EXHAUST PIPE ASSEMBLY (w/ DPF) |
Disconnect the exhaust gas temperature sensor connector.

Disconnect the No. 2 exhaust gas temperature sensor connector.

Disconnect the No. 3 exhaust gas temperature sensor connector.

Disconnect the No. 6 exhaust pipe air hose from the front exhaust pipe.

Disconnect the No. 7 exhaust pipe air hose from the front exhaust pipe.

Remove the 2 exhaust pipe supports.

- HINT:
- Remove the exhaust pipe supports before removing the No. 3 frame crossmember.
Remove the 3 nuts and front exhaust pipe.

Remove the gasket.
| 7. REMOVE SPEED SENSOR NT |
![]() ![]() |
Disconnect the sensor connector.
Remove the bolt and sensor.
Remove the O-ring from the sensor.
| 8. REMOVE SPEED SENSOR SP2 |
![]() ![]() |
Disconnect the sensor connector.
Remove the bolt and sensor.
Remove the O-ring from the sensor.


