2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

Taillight Relay Circuit

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

WIRING DIAGRAM

E199662E01

INSPECTION PROCEDURE


1. CHECK TAILLIGHT
  1. Turn the light control switch to the TAIL position.

  1. Check that the taillight turns on.

    OK:
    Taillight turns on.



NG
GO TO LIGHTING SYSTEM (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - BATTERY)

  1. B144569E05
    Disconnect the I1 clearance warning ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    I1-11 (TL) - Body ground
    Ignition switch ON, light control switch TAIL
    7 V or higher
    Ignition switch ON, light control switch not TAIL
    Below 1.5 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Clearance Warning ECU)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Taillight Relay Circuit (Aug 2013 – Jul 2014)Back Sonar Sensor LH Circuit (Aug 2013 – Jul 2014) →