2013-2015 Land Cruiser Prado · Service Manual Suspension

REMOVAL

Removal / installation · Vehicles built from Aug 2013

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. REMOVE REAR WHEEL

2. REMOVE REAR SHOCK ABSORBER ASSEMBLY LH (w/ Air Suspension)
  1. Support the rear axle housing.

  1. Disconnect the absorber control actuator connector.

  1. D028132
    Remove the bolt and disconnect the rear shock absorber assembly LH from the rear axle housing.

    NOTICE:
    Do not lower the rear axle housing excessively when disconnecting the rear shock absorber assembly LH with the pneumatic cylinder still installed to the vehicle.

  1. C214690
    Remove the nut, cushion No. 1 and rear shock absorber assembly LH.

  1. Remove the cushion No. 2 from the shock absorber assembly rear LH.


3. REMOVE REAR SHOCK ABSORBER ASSEMBLY LH (w/o Air Suspension)
  1. Support the rear axle housing.

  1. D028132
    Remove the bolt and disconnect the rear shock absorber assembly LH from the rear axle housing.

  1. D028133
    Remove the nut, cushion No. 1 and rear shock absorber assembly LH.

  1. Remove the cushion No. 2 from the shock absorber assembly rear LH.

← COMPONENTS (from Aug 2013)INSPECTION (from Aug 2013) →