2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

INSTALLATION

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. INSTALL SIDE TURN SIGNAL LIGHT ASSEMBLY LH
  1. Connect the connector.

  1. Install the light with the 3 screws.


2. INSTALL LOWER OUTER MIRROR COVER LH

  1. Install the outer mirror cover.

    1. B241700E01
      Insert the rib on the outer edge of the cover into the groove of the mirror body.

      NOTICE:
      Do not scratch the turn light.

      Text in Illustration 
      *1
      Rib

    2. B241701E01
      Confirm that the cover and mirror body are aligned properly, and then push the outer end of the cover to attach the outer claws.

      NOTICE:
      1. Make sure that the upper ribs of the cover shown in part A of the illustration are properly attached to the mirror body.
      2. Make sure that the ribs of the mirror body shown in part B of the illustration are not protruding from the cover.
      Text in Illustration 
      *1
      Rib

    3. B241702
      While making sure that the rib of the cover fits properly into the groove of the mirror body, squeeze the inner end of the cover and the mirror body together to attach the inner claws.

    4. B241703
      Push on the cover at the locations of the 8 claws to confirm that the claws are attached properly.


3. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH
  1. Connect the connectors.

  1. B231563
    Attach the 4 claws to install the mirror glass.


4. INSTALL OUTER REAR VIEW MIRROR LH
  1. Install the outer rear view mirror LH (Click here).

← INSPECTION (from Aug 2013)INSTALLATION (from Aug 2014) →