2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

REMOVAL

Removal / installation · Vehicles built from Aug 2013


1. REMOVE UPPER RADIATOR SUPPORT SEAL
  1. Remove the 13 clips and upper radiator support seal.


2. REMOVE V-BANK COVER

  1. A229925E01
    Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.
    Text in Illustration 
    *1
    Pin
    *2
    Hook


3. REMOVE AIR CLEANER CAP AND HOSE

  1. A224721
    Remove the air cleaner cap and hose.

    1. Disconnect the mass air flow meter connector, vacuum hose and ventilation hose and detach the 4 clamps.

    2. Loosen the clamp.

    3. Unfasten the 4 hook clamps, and then remove the bolt and air cleaner cap and hose.


4. REMOVE AIR CLEANER CASE SUB-ASSEMBLY
  1. Remove the air cleaner filter element.

  1. A224715
    Detach the wire harness clamp.

  1. Remove the 3 bolts and air cleaner case.


5. REMOVE AIR TUBE (w/ Secondary Air Injection System)

  1. A223569
    Remove the 2 bolts, 2 nuts and air tube.

  1. Remove the 2 gaskets from the air tube.

    NOTICE:
    Be careful not to damage the installation surface of the gaskets.


6. REMOVE EMISSION CONTROL VALVE SET (w/ Secondary Air Injection System)

  1. A223568
    Disconnect the emission control valve set connector.

  1. Disconnect the No. 1 air hose from the emission control valve set.

  1. A223570
    Remove the 3 nuts and emission control valve set.


7. REMOVE NO. 2 AIR TUBE (w/ Secondary Air Injection System)

  1. A223563
    Remove the 2 bolts, 2 nuts and No. 2 air tube.

  1. Remove the 2 gaskets from the No. 2 air tube.

    NOTICE:
    Be careful not to damage the installation surface of the gaskets.


8. REMOVE NO. 2 EMISSION CONTROL VALVE SET (w/ Secondary Air Injection System)

  1. A223562
    Disconnect the No. 2 emission control valve set connector.

  1. Disconnect the No. 3 air hose.

  1. A223564
    Remove the 3 nuts and No. 2 emission control valve set.


9. REMOVE IGNITION COIL ASSEMBLY

  1. A221430
    Disconnect the 6 ignition coil connectors.

  1. Remove the 6 bolts and 6 ignition coils.


10. REMOVE SPARK PLUG
  1. Remove the 6 spark plugs.

← COMPONENTS (from Aug 2013)INSTALLATION (from Aug 2013) →