C1879/79 Zero Point Calibration of Acceleration Sensor Undone
Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The stabilizer control ECU receives the yaw rate and acceleration sensor zero point information from the skid control ECU via CAN communication.| DTC Code |
DTC Detection Condition |
Trouble Area |
| 1879/79 |
A signal indicating that the yaw rate and acceleration sensor zero point calibration has not been performed is continuously received from the skid control ECU for 5 seconds. |
|
INSPECTION PROCEDURE
- HINT:
- When this DTC is output, obtain the calibration value of the yaw rate and acceleration sensor zero point first.
| 1. PERFORM ZERO POINT CALIBRATION |
Perform brake control system calibration (Click here).
| NEXT | |
| 2. RECONFIRM DTC |
Clear the DTCs (Click here).
Check for DTCs (Click here).
Result Result
Proceed to
DTC is output
A
DTC is not output
B
|
|
||||
| A | ||
| ||
