2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
  1. After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
  2. When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE DOOR SCUFF PLATE ASSEMBLY LH

B238732E01
  1. Put protective tape around the door scuff plate.

  1. Using a screwdriver, detach the 4 clips, 10 claws and 2 guides and remove the door scuff plate.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape


3. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH
  1. Partially remove the front door opening trim weatherstrip so that the lower center pillar garnish and center pillar garnish can be removed (Click here).


4. REMOVE REAR NO. 1 FLOOR STEP COVER (w/ Rear No. 2 Seat)

B238730E01

HINT:
Use the same procedure for all rear No. 1 floor step covers.

  1. Using a screwdriver, detach the 2 claws and remove the rear No. 1 floor step cover.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape


5. REMOVE QUARTER SCUFF PLATE LH (w/ Rear No. 2 Seat)

B238731
  1. Remove the 2 bolts and quarter scuff plate.


6. REMOVE REAR DOOR SCUFF PLATE LH

B238733E01
  1. Put protective tape around the rear door scuff plate.

  1. Using a screwdriver, detach the 3 clips, 6 claws and 2 guides and remove the rear door scuff plate.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape


7. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH
  1. Partially remove the rear door opening trim weatherstrip so that the lower center pillar garnish and center pillar garnish can be removed (Click here).


8. REMOVE OUTER LAP BELT ANCHOR COVER

B238735

HINT:
Use the same procedure for the other outer lap belt anchor cover.

  1. Detach the 3 claws and remove the outer lap belt anchor cover.


9. REMOVE LOWER CENTER PILLAR GARNISH LH

  1. B238736
    Remove the bolt and disconnect the front seat outer belt floor anchor.

  1. B238737
    Detach the 4 claws and 2 clips and remove the lower center pillar garnish.


10. REMOVE NO. 2 ASSIST GRIP PLUG LH

B238739E01

HINT:
Use the same procedure for the other front No. 2 assist grip plug.

  1. Using a screwdriver, detach the 2 claws and remove the front No. 2 assist grip plug.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape


11. REMOVE NO. 2 ASSIST GRIP LH

B238740

HINT:
Use the same procedure for the other No. 2 assist grip.

  1. Remove the 2 bolts.

  1. Detach the 2 claws and remove the No. 2 assist grip.


12. REMOVE CENTER PILLAR GARNISH LH

B238738
  1. Move the front shoulder belt anchor adjuster to the lowest position.

  1. Remove the bolt.

  1. Detach the 2 clips and 2 guides.

  1. Pass the front seat outer belt floor anchor through the center pillar garnish and remove the center pillar garnish.


13. REMOVE FRONT SEAT OUTER BELT ASSEMBLY

B241717
  1. Remove the nut and shoulder anchor.

  1. B239044E01
    Disconnect the pretensioner connector labeled A as shown in the illustration.

  1. w/ Pre-Crash Safety System:
    Disconnect the pre-crash safety connector labeled B.

  1. B239045
    Remove the bolt and seat belt.


14. REMOVE FRONT SHOULDER BELT ANCHOR PLATE SUB-ASSEMBLY

B245778
  1. Remove the 2 bolts and remove the anchor plate.

← COMPONENTS (from Aug 2013)REMOVAL (from Aug 2014) →