2013-2015 Land Cruiser Prado · Service Manual Suspension

INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT HEIGHT CONTROL COMPRESSOR (EXHAUST VALVE)

  1. C216447E01
    Measure the resistance of the exhaust valve.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      2 (L) - 1 (B)
      15 to 25°C (59 to 77°F)
      10 to 14 Ω

      Text in Illustration 
      *a
      Component without harness connected
      (Exhaust Valve)

  1. C216447E02
    Check the exhaust valve operation.

    1. Connect a positive (+) lead from the battery to terminal 2 (B), and a negative (-) lead to terminal 1 (L).

    2. Check the operating sound of the height control valve.

      OK:
      It makes an operating sound.

      Text in Illustration 
      *a
      Component without harness connected
      (Exhaust Valve)
      If the result is not as specified, replace the height control compressor.


INSPECT HEIGHT CONTROL COMPRESSOR (COMPRESSOR MOTOR)

  1. Check the compressor operation.

    1. C214513E02
      Apply 12 V battery voltage to the compressor motor and check the operation of the motor.

      OK:
      Measurement Condition
      Specified Value
      12 V battery positive (+) → Terminal 1 (B)
      12 V battery negative (-) → Terminal 2 (E)
      Motor operates

      Text in Illustration 
      *a
      Component without harness connected
      (Compressor Motor)

      NOTICE:
      1. Do not operate the height control compressor for 60 seconds or more.
      2. Stop applying voltage immediately if the compressor stops operating because a short will occur and the compressor motor will lock up, causing a flow of excessive current.

      If the result is not as specified, replace the height control compressor.

← REMOVAL (from Aug 2014)INSTALLATION (Aug 2013 – Jul 2014) →