2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

INSTALLATION

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. INSTALL REAR NO. 2 SPEAKER ASSEMBLY (for 14 Speakers)

  1. B241318E01
    Align the speaker with the door position pins labeled A.

  1. Install the rear No. 2 speaker with the 2 screws.

    NOTICE:
    Do not touch the cone of the speaker.


2. INSTALL REAR SPEAKER SET

  1. B239136E01
    Temporarily install the speaker by attaching the 2 claws of the speaker to the door panel.

  1. Install the rear speaker set with the 3 screws in the order shown in the illustration.

    NOTICE:
    Do not touch the cone of the speaker.

  1. Connect the connector.


3. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP LH

  1. B239678
    Attach the 3 claws to install the rear door inner glass weatherstrip as shown in the illustration.


4. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

  1. B239680
    Install the clamp to the door panel.

  1. Connect the rear door lock remote control cable assembly and rear door inside locking cable assembly.

  1. Connect each connector.

  1. B239608
    Attach the rear door trim board sub-assembly by attaching the 4 claws of the rear door inner glass weatherstrip as shown in the illustration.

  1. Attach the 9 clips and install the rear door trim board sub-assembly.

  1. Install the 3 screws.


5. INSTALL ASSIST GRIP COVER LH

  1. B241356
    Attach the 8 claws to install the assist grip cover.


6. INSTALL NO. 2 DOOR INSIDE HANDLE BEZEL LH

  1. B241355
    Attach the 3 claws to install the door inside handle bezel.


7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

← INSPECTION (from Aug 2013)INSTALLATION (from Aug 2014) →