2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT OIL QUALITY
  1. Check the engine oil for deterioration, water contamination, discoloration or thinning.
    If the quality is visibly poor, replace the engine oil and oil filter element (Click here).


INSPECT ENGINE OIL LEVEL
  1. Warm up the engine, stop the engine and wait 5 minutes. The engine oil level should be between the dipstick low level mark and full level mark.
    If low, check for leakage and add oil up to the full level mark.

    NOTICE:
    Do not fill engine oil above the full level mark.


INSPECT ENGINE OIL PRESSURE
  1. Remove the engine oil pressure switch (Click here).

  1. A223497E01
    Install an oil pressure gauge with an adapter.
    Text in Illustration 
    *1
    Oil Pressure Gauge
    *2
    Adapter
    *3
    Oil filter

  1. Warm up the engine.

  1. Measure the engine oil pressure.

    Standard Oil Pressure:
    Condition
    Specified Condition
    Idle
    29 kPa (0.3 kgf/cm2, 4.2 psi) or higher
    3000 rpm
    245 kPa (2.5 kgf/cm2, 36 psi) or higher

    If the pressure is not as specified, check the oil pump.

  1. Remove the oil pressure gauge and adapter.

  1. Install the engine oil pressure switch (Click here).

← ON-VEHICLE INSPECTION (from Aug 2013)COMPONENTS (from Aug 2013) →