P0299 Turbocharger / Supercharger Underboost
Diagnostic trouble codes · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
- HINT:
- Refer to DTC P0046 (Click here).
| DTC Detection Drive Pattern |
DTC Detection Condition |
Trouble Area |
| Accelerate vehicle with accelerator depressed halfway or more starting from a speed of 120 km/h (75 mph) or more for 2 minutes (make sure gear is fixed and does not change) |
The pressure is 55 kPa below the Target Booster Pressure for 80 seconds at an engine speed of 2800 to 4400 rpm (1 trip detection logic). |
|
| DTC No. |
Data List |
| P0299 |
|
- HINT:
- If DTC P0299 is stored due to the variable nozzle being stuck open, the following symptoms may appear:
- Lack of power
- Vehicle surge or hesitation under light or medium load
- If DTC P0299 is stored due to the variable nozzle being stuck open, the following symptoms may appear:
INSPECTION PROCEDURE
- NOTICE:
- After replacing the ECM, the new ECM needs registration (Click here) and initialization (Click here).
- After replacing the fuel supply pump assembly, the ECM needs initialization (Click here).
- After replacing an injector assembly, the ECM needs registration (Click here).
- After replacing the ECM, the new ECM needs registration (Click here) and initialization (Click here).
- HINT:
- Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
- Comparison of the data list items manifold absolute pressure and target booster pressure during acceleration under medium to high engine speeds can be used to determine the state of the problem.
- Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
| 1. CHECK FOR ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0299) |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG) and turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
Result Result
Proceed to
P0299 is output
A
P0299 and other DTCs are output
B
|
|
||||
| A | |
| 2. CHECK FREEZE FRAME DATA (FUEL PRESS AND TARGET COMMON RAIL PRESSURE) |
Enter the following menus: Powertrain / Engine and ECT / DTC.
Record the stored DTCs and freeze frame data.
Result Result
Proceed to
Difference between Fuel Press and Target Common Rail Pressure of freeze frame data is 20000 kPa or more
A
Except above
B
|
|
||||
| B | ||
| ||
